Thermal phenomena: water evaporation
Water is poured into a wide, shallow cylindrical cup (schematic drawing).
Apparatus: a fan, an open cup of water suspended from a spring of stiffness k, a heater, a temperature sensor and a two-channel recorder.A temperature sensor and an electric heater are immersed in water. The cup is suspended from a vertical spring, the elongation of which is measured by a sensor. Before the start of the experiment, the mechanical sensor was zeroed with an empty cup with a heater and temperature sensor installed in it, so its readings are determined only by the mass of the remaining water.
Graph of readings of two channels over time: curves I and II, marked points A, B, C, D, E.At point A, a fan is turned on, creating a constant flow of dried air. The water begins to evaporate and cool. At point C, without changing the fan mode, connect a constant power heater. The experiment ends at point E, when the water has completely evaporated.
Assume that the water has a uniform temperature. Air temperature, humidity and speed remain constant during the experiment. Heat flows from the air to the water according to P_air = β(T_air − T), where β is constant. Evaporation is the only cause of water loss. The water does not boil. Ignore splashing, leaks, the heat capacity of the cup and equipment, and any other heat transfer.
The graph is an idealized model of the measurement results. Assume that the rate of evaporation is constant from A to C and takes on a different constant value from C to E. Neglect the effect of water temperature on the rate of evaporation within each of these sections.
A two-channel recorder recorded the water temperature and the additional extension of the spring relative to the position of the empty cup. The channel labels were lost, so only the designations “curve I” and “curve II” remained on the graph. The conventional indication of channel u is plotted vertically, and the number of divisions n is plotted horizontally. The time from the beginning of the experiment is determined by the formula t = qn. Consider all points marked with letters to be located exactly at the nodes of the coordinate grid.
The following quantities are known:
- Air temperature: T_air = 30 °C.
- Time scale: q = 0.8 min/div.
- Temperature (in °C) as a function of the reading: T = 15.6 + 2.4u.
- Spring extension (in cm) as a function of the reading: x = u · sₓ; sₓ = 0.08 cm/unit.
- Spring stiffness: k = 30 N/m.
- Specific heat capacity of water: c = 4200 J/(kg · °C).
- Specific latent heat of vaporization: L = 2.26 MJ/kg.
- Gravitational acceleration: g = 10 m/s².
Questions for the assignment
- How many minutes after switching on the fan was the first steady state reached? Round your answer to one decimal place.
- Determine the initial mass of water. Express your answer in grams, round to whole numbers.
- Determine the rate of water evaporation before turning on the heater. Express your answer in g/min, round to the nearest hundredth.
- Determine the heat transfer coefficient β. Express your answer in W/°C, round to the nearest tenth.
- Determine the heater power. Express your answer in watts, round to the nearest tenth.